Tech 21 Introduces the Geddy Lee DI-2112 Pedal

Tech 21 DI-2112 Pedal

Building on their line of Geddy Lee signature models, Tech 21 unveiled the Sansamp DI-2112 at the 2020 Winter NAMM Show. The pedal combines features from GED-2112 rackmount and the SanAmp YYZ.

“The Drive pre-amp section is based upon the versatile SansAmp RPM, for a wide range of sonic possibilities,” the company writes. “The Deep pre-amp section offers thick, meaty tones. Saturation goes from clean in lower settings to increased harmonics and tube-like compression in higher settings. You can use either section independently or blend them externally direct to a mixing board as well as to two amplifiers.”

Get a full rundown of the DI-2112 in this NAMM interview from Premier Guitar:

The Tech 21 DI-2112 will be available soon with price point of $329.

Tech 21 DI-2112 Pedal Features:

Dual, all-analog SansAmp circuits with individual Level controls
Drive for gain and overdrive
Saturation for low-end beef with separate Level control
Blend to control the ratio of SansAmp Tube Amplifier Emulation and your direct instrument signal
Sweepable semi-parametric EQ, 170 Hz to 3.0 kHz, cut/boost 12dB
Tight switch adds definition to your notes in cleaner settings and makes distorted tones snappier 1/4-inch 1megOhm input
Dual balanced low impedance XLR outputs with Level Selector switch and Ground Lift to go direct to a PA desk or studio board
Dual 1/4-inch low impedance outputs with Level Selector switch
1/4-inch tuner output
Rugged, all-metal housing and jacks
Measures 6.375″l x 4.0″w x 1.75″h
Weighs just 19 oz.
Runs on 18V DC for increased headroom and clarity, via power supply or two 9V alkaline batteries (not included)

Get Bass Gear News in your inbox.

Stay up to date on the latest bass gear news (every Thursday).

Leave a Reply to Billybass Cancel reply

  1. Billybass

    Yawn!!!!

  2. Greg Blankenship

    I like it….

  3. Chet Wilson

    I’m definitely going to buy the DI-212 by SANSAMP