Tech 21 Introduces the Geddy Lee DI-2112 Pedal
Building on their line of Geddy Lee signature models, Tech 21 unveiled the Sansamp DI-2112 at the 2020 Winter NAMM Show. The pedal combines features from GED-2112 rackmount and the SanAmp YYZ.
“The Drive pre-amp section is based upon the versatile SansAmp RPM, for a wide range of sonic possibilities,” the company writes. “The Deep pre-amp section offers thick, meaty tones. Saturation goes from clean in lower settings to increased harmonics and tube-like compression in higher settings. You can use either section independently or blend them externally direct to a mixing board as well as to two amplifiers.”
Get a full rundown of the DI-2112 in this NAMM interview from Premier Guitar:
The Tech 21 DI-2112 will be available soon with price point of $329.
Tech 21 DI-2112 Pedal Features:
Dual, all-analog SansAmp circuits with individual Level controls |
Drive for gain and overdrive |
Saturation for low-end beef with separate Level control |
Blend to control the ratio of SansAmp Tube Amplifier Emulation and your direct instrument signal |
Sweepable semi-parametric EQ, 170 Hz to 3.0 kHz, cut/boost 12dB |
Tight switch adds definition to your notes in cleaner settings and makes distorted tones snappier 1/4-inch 1megOhm input |
Dual balanced low impedance XLR outputs with Level Selector switch and Ground Lift to go direct to a PA desk or studio board |
Dual 1/4-inch low impedance outputs with Level Selector switch |
1/4-inch tuner output |
Rugged, all-metal housing and jacks |
Measures 6.375″l x 4.0″w x 1.75″h |
Weighs just 19 oz. |
Runs on 18V DC for increased headroom and clarity, via power supply or two 9V alkaline batteries (not included) |
Yawn!!!!
I like it….
I’m definitely going to buy the DI-212 by SANSAMP